With hand-held equipment, application should be made on a spray-to-wet basis. Product must be diluted prior to use.
Dosing rates: Make a general spray solution of 1.0 fl. oz. to 10.25 fl. oz. per gallon of water
Dilute and spray
Use with AB™ Brand Adjuvant on any weed on or above the water surface
For use on emerged aquatic weeds and brush in aquatic sites, forestry, habitat restoration areas, non-crop and other listed application sites.
There is no restriction on the use of treated water for irrigation, recreation, or domestic purposes.
Drinking Water Restrictions Do not apply this product directly to water within 1/2 mile up-stream of active potable water intake of flowing water, or within 1/2 mile of active potable water intake in a standing body of water. The intake must be turned off for 48 hours or tested below state requirements.
This product is registered with the U.S. Environmental Protection Agency (USEPA) in the following states. Registration status may be subject to change.
For specifics on aquatic pesticide application permitting, contact your local state agency. Click here for a list of agencies.
Alabama Arizona Arkansas California Colorado Connecticut Delaware Florida Georgia Hawaii Idaho Illinois Indiana Kansas Kentucky Louisiana Maine
Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma
Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington West Virginia Wisconsin Wyoming Puerto Rico
Water Care Solutions
As the lake and pond care experts for over 50 years, we are dedicated to providing complete solutions for your water.
Thank you for visiting! Always read and follow product label instructions.